Confused. Solder to r4p4 or cr511 bottom of slim coronaV1 rgh1 coolrunner

[skandalus]

I am following a tutorial and I am confused at where I solder one of the wires,

I am doing a rgh1 install to a corona v1 using the coolrunner revc chip. Any help would be helpful. Thank you.

 

[playingmax]

use r4p4 so u dont have to remove xclamp.

 

[skandalus]

use r4p4 so u dont have to remove xclamp.

What is the difference? Are both connected to each other? Would I have different boot times depending on which I solder to? Questions Questions losing hair!

 

[playingmax]

or u could use ft3t10 a lot easier to work with.

- - - Updated - - -

or u could use ft3t10 a lot easier to work with.

 

[skandalus]

What difference does it make which point I solder to?

 

[johnnyblackout]

Aren't all slims RGH2 only?

 

[skandalus]

Aren't all slims RGH2 only?

Someone else said that to me but the tutorial I am following says that I can.

http://www.se7ensins.com/forums/threads/jtag-rgh-r-jtag-xbox-360-ultimate-exploit-guide.804054/

So far I have read my nand 4 times ( to be safe ) wrote ecc, flashed coolrunner, and now in the process of soldering stuff on the motherboard.

It says that for RGH1 I need a multi-cap addon which I have bought.
It says for RGH2 I need a CPU reset cleaner which I have NOT bought as it's used on RGH2. I chose RGH1 over RGH2 because the tutorial says boot times are faster on RGH1.

what i have is a slim corona v1, coolrunner revc, multicap addon, tx jrunner nandx qsb corona.

 

[AllyNerd]

If you have a multimeter you will find out that all the cpu_rst point are connected. And all slims are rgh2 only phats have rgh1 and rgh2 so you will be wiring up your cool runner with rgh2 wiring (I.e. Not using point a ok cool runner and using point e and f). All the pictures are in jrunner under images so prob best use that.