Okay, so I followed the direct wire install on reading the nand with Nandx. I am positive my points were good and good joints etc...
But I got this in J-Runner:
I didn't know what that ment so once it was done reading I just unplugged nandx, unsoldered wires, and then unplugged PSU(Probably should of unplugged it first)
I then tried to boot the xbox to make sure everything was alright, but it would turn on but wouldnl't boot the dash. The ROL would just flash green.
Please, please help me!
But I got this in J-Runner:
Code:
Arm Version: 3
Flash Config: 0x01198010
Reading Nand
[B]Error: 250 reading block 28B[/B]
Done!
Initializing Nand..
Arm Version: 3
Flash Config: 0x01198010
Reading Nand
[B]Error: 250 reading block 28B[/B]
Done!
Comparing...
Nands are the sameI then tried to boot the xbox to make sure everything was alright, but it would turn on but wouldnl't boot the dash. The ROL would just flash green.
Please, please help me!
