Controller doesnt sync

[Djirko]

Hello,
strange thing happened. I did the rgh as always. I booted to xell, took cpukey, made new nand, installed it through xell with rawflash. And now when im booting to dashboard i cant sync my wireless controller. Im pressing sync button on both console and controller, but after few flashes console stops and controller continues to search for sync. Too bad i dont have any wired controllers at the moment, so cant check that. Any ideas? Console is phat (falcon).
Btw, i checked console before starting doing rgh and everything were fine.

 

[Astromine]

If you are using HDMI sometimes the controller won't sync with the console until your TV is turned on and set to HDMI. That's one possibility that may help as long as everything went well with the RGH.

 

[Djirko]

Well im not using hdmi, im using simple cable.
Well the situation is like that. For example console turns on by pressing guide button, but after booting it doesnt sync with controller. When i try to sync them ( tried more than one controller ), light starts to go around circle and starts to blink like it found the controller, but after few blinks, consoles just stops blinking and the controller continues to search for console.

---------- Post added at 16:38 ---------- Previous post was at 16:34 ----------

Hmm strange, i tried another cable to tv, the component one. It doesnt show anything at all, on tv and hd positions doesnt show anything, but it works with another console.

 

[Astromine]

Is there a switch on the side of the cable where you can switch it between High Definition and Standard Definition?

 

[Djirko]

Is there a switch on the side of the cable where you can switch it between High Definition and Standard Definition?

Yes there is. I tried both, none of them worked, while simple cable without switch works. Both cables works on other console.

I will try to get wired controller tomorow, or cable for wireless controller.

 

[Astromine]

Hmm that's odd. Not sure what the problem may be. Maybe someone else here has a suggestion for you.

I hope everything works out for you.

 

[Justice1231]

I had a similar problem but not with rgh, try this turn the xbox off, uplug the power, remove the power supply, remove the hard drive and leave it for 1 min. plug in the hard drive plug in the power and then try synching and see if it helps.

 

[Astromine]

I had a similar problem but not with rgh, try this turn the xbox off, uplug the power, remove the power supply, remove the hard drive and leave it for 1 min. plug in the hard drive plug in the power and then try synching and see if it helps.

Yeah I was thinking the same thing but just assumed that would be everyone's first thing they'd try but you're absolutely right.

 

[Djirko]

I had a similar problem but not with rgh, try this turn the xbox off, uplug the power, remove the power supply, remove the hard drive and leave it for 1 min. plug in the hard drive plug in the power and then try synching and see if it helps.

Tried that hunderds of times Well, i guess i will have to find the wire for controller and try that.

 

[spandaman]

Sync the controller to another 360 console then it should re sync back to your original one. I had this exact issue on a trinity once, after sync the controller to a different box it worked fine


Sent from my iPhone using Tapatalk