okay I just added a LED to my controller and I just happened to have done it right untill I noticed that the wire was to long for the top of the case then after re-soddering it it didn't light up I tooke my comunicator out of the top and it lit up and it ws very dim so I was wandering if it is posible to narow a ciruit not fully close it and can I fix this?
Controller? plz help fast
- Thread starter adb007123
- Start date
what are you saying.. i dont fully understand you and because no one else is replying, i dont think they understand either...
why dont you just get a multimeter (or a voltmeter) and find two points on the controller mainboard that give out the correct voltage for the led.. i have done this at least 12 times using many different points and it has worked fine every time.
good luck with whatever method you choose..
why dont you just get a multimeter (or a voltmeter) and find two points on the controller mainboard that give out the correct voltage for the led.. i have done this at least 12 times using many different points and it has worked fine every time.
good luck with whatever method you choose..