RGH Coolrunner and fan Question?

[jayfig]

Ever since I installed the coolrunner in my Falcon xbox I havent been able to attach my 3rd party fan system (Intercooler) cause my console wont boot. Is there anything I can do to keep my console extra cool with the coolrunner drawing that extra power?

 

[playingmax]

yes just go into fsd setting under fan speed n increase it.

 

[jayfig]

Is that only while your in fsd or does it reset after the console turns off?

 

[superspeed]

If your console boots into fsd it will automatically speed the fans back up.

 

[sick360mods]

or you can just change the speeds on your nand

 

[AMIT]

You can set Fan Speed using FSD ,Dash Launch ,J-Runner(V2) !

or This (it will also work on retail nand)!

 

[BL4K3Y]

When you adjust the fan speed in FSD, that configuration stays because it alters values in config/SMC I believe.

 

[superspeed]

I thought it just saved in the settings for fsd and not to the console itself. Because if you remove the fsd file from your hdd and fsd does not boot at startup the fans are on auto.

 

[BL4K3Y]

You could be right actually, it's a NAND modification I'm thinking of :facepalm: lol.

*BL4K3Y isn't on the ball today :crazy:.

 

[AMIT]

I thought it just saved in the settings for fsd and not to the console itself. Because if you remove the fsd file from your hdd and fsd does not boot at startup the fans are on auto.

yes , i also seen this on a Xenon Jtag !

I think i saw some Fan-speed Patcher (about some months ago),It's in a Zip file and it's have some Xex s like 100.Xex ,90.xex etc .

 

[superspeed]

Yeah it's like setting the game paths and saves in the fsd settings. So everytime you go into fsd the fan goes to what percentage is save into the settings.