ANSWERED Coolrunner Flash Via LPT Help

S

subplay

Full Member
Feb 22, 2012
28
0
Hello all,

I need some help here, I cannot find settings anywhere.

I know how to load the JED Files and I know where to find the program button in impact the onlything I cannot do is bloody flash the things it just comes up flash fail..

Now I think its a issue with the lpt cable or port...

I have the official lpt cable not a clone or sod all.

I load impact impact and load the jed file i want.
I goto output, then goto cable setup..

Then I get met up with

Parallel Cable 3
Parellel Cable 4

For the official cable which one is it?

Eitherway I have picked both and none of them will flash it.

All I get is program failed..
There is no where I can setup speeds or nout like that, and because im using xp 32 bit I am using v12.2 as recommend.

Please someone can anyone help me.. This is driving me nuts.. I am really sorry to ask I bet your fed up of the same questions

Oh and does the side switch be on nor or prg
thnks again all
 
S

subplay

Full Member
Feb 22, 2012
28
0
Ok thankyou but I have a new problem now.

initializing parallel port at 0x8800
Warning: TDO seems to be stuck at 1

So first of all have I got the correct port and if not where do I find my port address on windows xp, I have looked everywhere

My LPT on motherboard settings is set to EPP+ECC is this correct?

And finally does the coolrunner have to be on to flash? it is currently connected to xbox with the lpt wire going into it, wired up and console turned off. with a power source coming from the dvd power and obviously the 3.3v and ground are too connected

Thanks in advance
 
S

subplay

Full Member
Feb 22, 2012
28
0
No
The Coolrunner is connected to the DVD Power connector this is the only cable that came with the coolrunner kit obviously apart from the lpt cable.

But no its a original cable from CK3
 
You must log in or register to reply here.