CK3 LITE Coolrunner Programming Files????

[cyklon]

Hello,

I have a cr3 lite and am trying to rgh1 my falcon xbox, i saw when programming my coolrunner in impact that there were two files for this one was called falcon_en and the other was called falcon, i was just wondering if the difference in these file plays a big role in booting xell ?

(because currently i cannot boot xell)

Cyklon

 

[Utmad]

Falcon_en is for when you have a Demon installed, this is selected when you tick the Demon box in the coolrunner programming section.

 

[rghpro]

Do you have a Photo of your CR3Lite?

A picture is needed because there are lots of fake CR3 lites out there and TX cannot support a fake cr3lite, so please post some pictures of the cr3lite and your soldering so you can be helped better.

 

[Martin C]

(because currently i cannot boot xell)

Complete the template please:

[h=3]TEMPLATE: RGH/JTAG help[/h]

 

[cyklon]

TX Product(s) used: CR3 Lite
Console Type: Falcon
NAND size: 16
Dashboard version: e.g 2.0.8955
CB version: 5771
Screenshot of NAND details from J-Runner:

J-Runner log:
updflash.bin: N/A
Image of Coolrunner:

Images of close-up soldering:



Description of problem:Wont boot xell, coolrunner is programmed with falcon.sxvf, wiring is for rgh1

Was the console working before you started: Y

Do you get a green debug light appear on the RGH chip every 4-5 seconds: Y

How long is the light on for each time:1 second

 

[hersheys247]

Does the console boot stock nand?

Take and post a pic of your stby_clk point near hana

You have too much interferencewith your sstby_clk alt point you did and might be the cause

 

[cyklon]

Yes the stock nand does boot, attached is a picture of the destroyed point.

 

[Martin C]

Try setting #4 on S4.

Do you have J-Runner logs of what's been written to the console and what timing file you used?

If you don't, get it back to stock and then start from the beginning (this time save the logs).

 

[cyklon]

Ok I'll try that, but i can't write anything with j runner because it's the wrong arm version, I've been using 360 nand flasher which gives me better results but I have used nandpro to write the ecc file.

With #4 on s4 on the dbg light doesn't flash

 

[Martin C]

ok - bear in mind this is a TX product support site, so help will be limited.

 

[cyklon]

Ok , not a problem , but with the wiring how exactly does the length of certain cables affect the likelihood of booting?

 

[Martin C]

On RGH1 it doesn't - not really.

Falcon RGH1 consoles are the best at booting of any RGH console.

Looking closer at your install, the problem is a mis-match of soldering.

I see E & F wires soldered but they're not used for RGH1. There's nothing soldered to A, which is where PLL goes.

Look at the installation images again and make sure you have it all done for RGH1.

 

[cyklon]

Thanks for the reply,
its my fault it is not an up to date image, it is an image of the same coolrunner when i installed it onto another xbox which needed rgh2 , so right now i have soldered the wires by following this image
View attachment 25065