RGH Coolrunner Rev C Alternative post_Out (yellow) point Corona v1

[arshad145]

Please Give some pics to solder Post_out :facepalm:
There is already a thread about this but no pics and not even the name of the pad or point :/

 

[arshad145]

Plzz reply ...

 

[jery911]

here you go

 

[arshad145]

This is the original one its broken
I want the alternative one

 

[arshad145]

Here's The POST!: http://team-xecuter.com/forums/showthread.php?t=100088 but there are no pics

 

[arshad145]

this one srry : http://team-xecuter.com/forums/showthread.php?t=76145

 

[jery911]

This is the original one its broken
I want the alternative one

you didn't mention that in your og post, but here you go.

EDIT: aha never mind you did mention it my bad, heres the pic tho.

 

[arshad145]

But where is it found under heat sink ?

 

[jery911]

But where is it found under heat sink ?

yes, right under the heat sink

 

[arshad145]

I will post later for results thxs again

 

[jery911]

I will post later for results thxs again

No Problem!

 

[arshad145]

Can I keep the heat sink without thermal paste?

 

[gazcoigne]

are you serious? you need to reapply new thermal past if you remove it from the board, otherwise the console will overheat and shut off within minutes of turning on.

unbelievable jeff!!

and if you've f**ked up the large post point on the underside, you'll defo f**k up the tiny one under the heatsink. be careful!!

 

[arshad145]

How to fix a missing pad? i unsoldered it together with the post_out pad

 

[gazcoigne]

what are you asking?

if the pad is gone, its gone, solder to the point under the heatsink like you were told!!

 

[arshad145]

But can't I repair it?

 

[gazcoigne]

you dont need to repair the pad no, use the topside post point as you have been told numerous times. the broken point will not stop the console from working.