FIXED CoolRunner Rev C + Xecuter Corona Postfix Adapter V2

[ModitNow]

Hi I need a little help here with a xbox360 E Corona V6 it seems like. I have installed the the Xecuter Corona 4GB Nand RW Kit V4 and got my nand readings. Installed the TX Corona QSB Upgrade then the TX CoolRunner Rev.C and last but not least installed the TX Cornona Postfix Adapter V2. My issue here now i have seen on other threads where there is a wire connecting the postfix adapter to the the Coolrunner but that was a CR3. I would like to know which point on the Coolrunner rev.C am i to connect to the postfix adapter v2. Leaving some pic here so you can see what am saying. I am just doing this to get the files for installing an LTU2 so its not permanent don't care about best booting time or anything like that. Also these models 360E don't have the shield of the video that is normally used to solder the ground wire so wanted to know if where it is on the usb is ok.

Images:

 

[jsinger47]

Ground is ground. All those shields are ground. So anywhere there is fine.

You can solder to any of the points on the postfix adapter. The different lengths are used for tuning. Since you only need it to boot once, anything should work.

From your pics, you have the yellow C wire soldered to a POST point which on corona 3+ is actually ground, so that won't work. Solder the yellow wire to anywhere on the postfix.

Also, make sure you bridged the R2CXX points appropriately.

 

[ModitNow]

Thank you so much really didn't know what should have gone to the postfix adapter. Will work on it as soon as i get in from work.

 

[ModitNow]

Thanks "jsinger47" took you recommendations and everything work out fine got it to glitch got my keys extracted my files and everything is working fine now thanks again.