First off sorry if this is in the wrong spot as i did not see a better place or just a simple 360 support section.
Anyway i have this corona V4 4GB. has a liteon DG16D5s dvd drive. console is 100% stock not even LTU firmware.( not yet at least) works great no issues. at least none that effect me.
Ok enough babble. So if the console has ben unplugged and i go to plug it in. if i hit the eject button first its just beeps. it will not eject or even turn on, just a beep.
I have to hit the power button first then it works fine after that. i have never seen this before and just want to know if there is a fix or is there something going on with the ribbon cable or RF ROL board or is there something i need to worry about?
Also if i RGH it then when i go to run xell it wont be the eject button that starts it up. i am able to select a different button to get Xell right?
Thank you in advance.........
Anyway i have this corona V4 4GB. has a liteon DG16D5s dvd drive. console is 100% stock not even LTU firmware.( not yet at least) works great no issues. at least none that effect me.
Ok enough babble. So if the console has ben unplugged and i go to plug it in. if i hit the eject button first its just beeps. it will not eject or even turn on, just a beep.
I have to hit the power button first then it works fine after that. i have never seen this before and just want to know if there is a fix or is there something going on with the ribbon cable or RF ROL board or is there something i need to worry about?
Also if i RGH it then when i go to run xell it wont be the eject button that starts it up. i am able to select a different button to get Xell right?
Thank you in advance.........
