This Xbox was working with DemoN before I put it into the case. After it was put in the case, it wouldn't boot, I could just hear the click sound, no lights. I removed the motherboard from the case and only once after several attempts it booted.
So I decided to check connections and while removing Demon I lifted points WE, ALE, CLE, RE. I tried to fix them by wiring from nand directly. Went bad again because I lifed RE point on nand. Then I removed everything (coolrunner, demon, all wires except those to nand) and wrote original nand. Same problem: beep and no lights.
Since there is a small trace left going from the nand I thought I might wire it on the back of the motherboard. Didn't work.
Any ideas how to fix this?
So I decided to check connections and while removing Demon I lifted points WE, ALE, CLE, RE. I tried to fix them by wiring from nand directly. Went bad again because I lifed RE point on nand. Then I removed everything (coolrunner, demon, all wires except those to nand) and wrote original nand. Same problem: beep and no lights.
Since there is a small trace left going from the nand I thought I might wire it on the back of the motherboard. Didn't work.
Any ideas how to fix this?
Last edited:
