TX Product(s) used: CR3 Lite, J-runner programmer
Console Type: corona
NAND size: 16mb
Dashboard version: 16203
CB version: 13181
Screenshot of NAND details from J-Runner:
(attach an image to your post)
J-Runner log:===================================================
Saturday, March 22, 2014 10:48:49 PM
J-Runner v0.3 Beta (4) Started
It's advised to run in administrator mode on Windows 8
WARNING! - Your selected working directory already contains files!
You can view these files by using 'Show Working Folder' Button
Checking Files
Finished Checking Files
RGH2 Selected
Initializing nanddump1.bin..
Corona
Nand Initialization Finished
ECC created
updflash.bin log (if applicable):
Image of Coolrunner
ics coming soon
Images of close-up soldering to motherboard:
coming soon. but I can assure you the soldering is superb.
Description of problem: Corona V1 will not boot into xell. Green led blinks continuously but never goes solid or stops blinking. I've tried all timing files with phat/slim settings. Also when I write the original nand back to console, it will only boot if dips are off..If dips are on, green led stays lit, but the console will not boot. I've been at this for 3 days..
Was the console working before you started: y
Do you get a green debug light appear on the RGH chip every 4-5 seconds: y
How long is the light on for each time: about 2-3 secs
Console Type: corona
NAND size: 16mb
Dashboard version: 16203
CB version: 13181
Screenshot of NAND details from J-Runner:
(attach an image to your post)
J-Runner log:===================================================
Saturday, March 22, 2014 10:48:49 PM
J-Runner v0.3 Beta (4) Started
It's advised to run in administrator mode on Windows 8
WARNING! - Your selected working directory already contains files!
You can view these files by using 'Show Working Folder' Button
Checking Files
Finished Checking Files
RGH2 Selected
Initializing nanddump1.bin..
Corona
Nand Initialization Finished
ECC created
updflash.bin log (if applicable):
Image of Coolrunner
ics coming soonImages of close-up soldering to motherboard:
coming soon. but I can assure you the soldering is superb.
Description of problem: Corona V1 will not boot into xell. Green led blinks continuously but never goes solid or stops blinking. I've tried all timing files with phat/slim settings. Also when I write the original nand back to console, it will only boot if dips are off..If dips are on, green led stays lit, but the console will not boot. I've been at this for 3 days..
Was the console working before you started: y
Do you get a green debug light appear on the RGH chip every 4-5 seconds: y
How long is the light on for each time: about 2-3 secs
Last edited:
