RGH Corona v2 Help

[XeXDevelopers]

I have
-cr3 Lite
-R/q Kit
-Jr Programmer V2
-Corona v2 Motherboard
-2 oz. Non-Spill Rosin Soldering Paste Flux
-Silver-Bearing Solder (1 Oz.)
-5-Piece Basic Soldering Set

Anything i am missing? Also is the "DRX" To pull keys Do i really need it or can i do it with what i have now? If i am missing anything please link me to where i can buy them!

 

[nofeloniesyet]

I have
-cr3 Lite
-R/q Kit
-Jr Programmer V2
-Corona v2 Motherboard
-2 oz. Non-Spill Rosin Soldering Paste Flux
-Silver-Bearing Solder (1 Oz.)
-5-Piece Basic Soldering Set

Anything i am missing? Also is the "DRX" To pull keys Do i really need it or can i do it with what i have now? If i am missing anything please link me to where i can buy them!

what you have now is fine,jr programmer wont be needed,only the r/w kit.and dgx hasnt been needed in quite some time,since we got the leaked bootloaders (precompiled ecc files),so the keys can be pulled with any run of the mill glitcher good luck!

 

[XeXDevelopers]

Dont i need the Jr programmer to program the Cr3 Lite?

 

[nofeloniesyet]

Dont i need the Jr programmer to program the Cr3 Lite?

damnitt im sleepy,your right,forgot bout that,lol

 

[jligg]

If its definitely a v2 you need to check and make sure it has the post traces in case you need a postfix adapter..more then likely you wont. I heard for a long time that there was v2 without the traces but I never seen one. Then out of nowhere 2 in a row that were missing the traces just recently.

- - - Updated - - -

http://team-xecuter.com/forums/showthread.php?t=146222

theres another one and how to check

 

[XeXDevelopers]

If its definitely a v2 you need to check and make sure it has the post traces in case you need a postfix adapter..more then likely you wont. I heard for a long time that there was v2 without the traces but I never seen one. Then out of nowhere 2 in a row that were missing the traces just recently.

- - - Updated - - -

http://team-xecuter.com/forums/showthread.php?t=146222

theres another one and how to check

Its the same one that everthing came off of. Same board etc

 

[alexander_1333]

Set the multimeter to 20Kohms and check the ohm value between post_out and GND.Post results.

 

[nath247]

Be careful with that soldering iron. It's always a good idea to get a temperature controlled iron.

 

[BrockThunderjam]

Be careful with that soldering iron. It's always a good idea to get a temperature controlled iron.

You can do just as much damage with a temp dial iron that one that's set. As long as you know how to use it you should be fine.