FIXED Corona V2 no boot after flash DGX file

G

gianluca84

Noob Account
Dec 15, 2012
7
0
Hi guys.

Today I've installed correctly a DGX 1.0S on a Corona V2. After reading NAND (system only and full dump) I have flashed the ECC Corona file (also tried alternate version) but it won't boot.

The console only sound the start "beep".
Obviously I've de-soldered both wires: oscillator short to cap, and 4-6 NAND pins (I'm using an micro-sd to usb adapter).

However when I flash again the original dump, the console start normally and DGX try to glitch.
So I've flashed again ECC Corona file, but with the same results. Only "beep" and no boot, no Fan spin, no leds, no DGX glitch attempts.

Many flash attempts executed by J-Runner, nandMMC and also AutoGG: same results.

Have you any ideas about this issue?
Thanks.
 
Last edited:
G

gianluca84

Noob Account
Dec 15, 2012
7
0
Re: [FIXED]Corona V2 no boot after flash DGX file

I've fix the issue.

It was all right, Xbox360 now boot correctly after flash the DGX file.

What I did to fix? Nothing of special: I've only unplugged the switch on/switch off board from the xbox360 motherboard and re-plugged it again, so touch the button and it boot fine.

I managed to get the key in minutes.
Maybe the Unplug & re-plug method can be useful to others! ;)
 
Last edited:
You must log in or register to reply here.