Corona v2 no RGH Red Dot power off

[ahnabil]

Folks, received this console to fix, it wasn't powering on at all, the owner found a way to remove all the pads :facepalm::facepalm:

follow up with this thread
http://team-xecuter.com/forums/showthread.php?t=146714&p=1012327

anyway did what should be done and was able to boot also with the help from moderator bl4k3y was able to read and write the nand too.

so i read the nand made a copy prepared ecc and wrote ecc, everything is fine.

i've soldered in cr3 lite. but the strange started to happen.

as soon as i plug in the power cord the console powers on. tries to glitch for a sometime, then the console powers off with a red dot and don't want to power on again, overheating?? NO!! the room has AC and the temp is less than 23C

checked all the soldering etc.

flashed the original nand and the console boots fine !

don't know whats else i can do

the console is on 13599 dash ?? RGH1 or RGH2 don't know?

check images.

 

[jligg]

After looking at the soldering I dont see how that console doesnt catch on fire when ya turn it on

 

[hersheys247]

Are you supposed to fix it, or is that how u got it? I'm confused!

 

[skillet34]

After looking at the soldering I dont see how that console doesnt catch on fire when ya turn it on

Fake cr too :/

 

[ahnabil]

as i said the console boots fine and there aren't any pads to solder to, ignore half of the topic about reading and writing the nand. just is there any troubleshooting steps that can be done for RGH?
the console boots fine with original nand.

 

[ahnabil]

Are you supposed to fix it, or is that how u got it? I'm confused!

i'm supposed to fix it.

 

[jsinger47]

Since you have a clone coolrunner, we offer no support.

We'll be more than happy to help when you get TX products.

Closed