DGX Corona v2 Not booting Xell

[Noob.Si.BOT]

I got a stubborn corona v2 here and its been giving me no boot what so ever. I got my my wires lentghs changed enough times and still nothing. Ive tried many possible sizes and wires no boot still. My information and pictures as below:

Mobo: Corona v2
Dashboard: 16202
Device: DGX 1.0S, 4GB qsb.

*I tried 8cm on D pad, 12cm on C pad. 5cm on D, 8cm on C. 10cm on D, 15cm,20,25cm,30cm,35cm,40cm. Still no boot.

Log:

===================================================
Saturday, February 09, 2013 2:40:12 PM

J-Runner v0.2 Beta (286) Started



Checking Files
Finished Checking Files
Initializing nanddump1.bin..
Nand Initialization Finished
Writing to E:\ from C:\Users\Public\Documents\NAND Tests\451323313505\nanddump1.bin
Done!
in 0:04:577 min:sec:ms
Writing to E:\ from C:\Users\Public\Documents\NAND Tests\451323313505\nanddump1.bin
Done!
in 0:03:713 min:sec:ms
Writing to E:\ from C:\Users\Public\Documents\J-Runner v02 Beta (280) Core Pack\common\DGX\CORONA_4GB_DGXv2.ecc
Done!

 

[jligg]

Cut your c and d wire as short as possible. Just enough to reach the points. Should boot almost instantly

Sent from my ADR6400L using Tapatalk 2

 

[XEX DriZzy]

What does the console do when you try to boot it? Does it try to glitch and just doesn't? Also, if you have a corona v2 you may want to check and see if it has a post_out trace on the top of the board. I believe that some corona v2 models it is missing on. Just remove the xclamp and it's under the heatsink on the top if the board.

 

[FlipMode]

DIP 8 on?

Did you try the alternate Corona DGX ECC's?

 

[one_360]

and I have Corona V2 Use CR3 Dip on (8) But just Red No blink Green Led No Respon And I Flash yhe ecc use CORONA_4GB_DGXv2.ecc But still no Respon C cable 55cm And D cable 10 cm Anyone have a solution :facepalm: For this

 

[Antalpromille]

Show all your work, CPU_RST for example. If it doesnt blink, something in your wiring is faulty.