RGH Corona V2 rgh

[unkn0wn.92]

Corona V2 rgh experience

hey guys today i got my 4gb r/w kit and i tried to install it Wired and it works great dumped the nand and installed a CR Rev C with a Crystal with these setup
Jumpers all Default , cpu_rst cut 12cm from standard 55cm blue wire from slim and the rest used them for post_out route it around the X-Clamp and used 1-2 timing file i will try and will attach the result hope this will work xD

Pic for my r/w qsb

 

[Spaz2203]

...ok

Sent from my GT-P5113 using Tapatalk 2

 

[moco]

Your better off soldering the qsb directly, but each to their own. If you dont, I suggest at least securing that qsb to the board with double sided tape and securing the wires. One light tug on that qsb and you could sever the conection on the nand points. Good luck anyway.

 

[unkn0wn.92]

well i finally get it to glitch and this is my experience
Jumpers all default , Wires Length "CPU_RST" cut 12cm from standard 55cm slim package and the rest used them for "POST_OUT" , Timing Files
1-2 = 4,3,3,2,3 cycles and the switch to PHAT the SLIM switch doesn't boot
1-3 NO BOOT SLIM & PHAT
2-2 NO BOOT SLIM & PHAT
2-3 NO BOOT SLIM & PHAT

i didn't try the other files !

 

[unkn0wn.92]

Your better off soldering the qsb directly, but each to their own. If you dont, I suggest at least securing that qsb to the board with double sided tape and securing the wires. One light tug on that qsb and you could sever the conection on the nand points. Good luck anyway.

thanks for the advice m8 but its hard to ship it to my Country it will take 7-10 days

 

[oO Elite Oo]

Well cycles arnt that bad for DIY method.

 

[unkn0wn.92]

Well cycles arnt that bad for DIY method.

Yea that is why im happy for its my first corona and sometimes it boot faster than my trinity o,O
sometimes it took 6 cycles To boot at first boot but this rarely happens

 

[zphingphong]

Re: Corona V2 rgh experience

hey guys today i got my 4gb r/w kit and i tried to install it Wired and it works great dumped the nand and installed a CR Rev C with a Crystal with these setup
Jumpers all Default , cpu_rst cut 12cm from standard 55cm blue wire from slim and the rest used them for post_out route it around the X-Clamp and used 1-2 timing file i will try and will attach the result hope this will work xD

Pic for my r/w qsb

I'm actually doing the same thing, but my console refuse to turn on (fan doens't even run) when I connect the single end point (the one that's separate from others). Good thing is when I disconnect it, it runs fine. Have you seen this issue?