corona v3 red led error 0101

[JOLLY_JOKER1984]

hi I tried on a rgh crown v3 I extracted the nand and wrote the file .ecc I just noticed that you have not bridged the points RC2C7, RC2C6, RC2C10 and the R2C4 and I've welded after writing the file .ecc and I gave red LED, then I put the nand origilnale and I always red LED (the original nand I think it is good because it gives me the correct values ​​of dashbord).
I tried to press the cpu in order to better adhere the balls soulder but always red LED

 

[JOLLY_JOKER1984]

reballing???????????

 

[chase]

Fill the template with all logs and pics

Also, you had another THREAD which was closed for fake product used.. have you installed a genuine tx glitch chip yet?

 

[JOLLY_JOKER1984]

Fill the template with all logs and pics

Also, you had another THREAD which was closed for fake product used.. have you installed a genuine tx glitch chip yet?

I unsoldered the bogus product and sent back to the seller that I cheated.
the problem persists, they told me that with error 0101 you have to make a reballing it?

 

[BL4K3Y]

Complete the correct template if you want help.

 

[JOLLY_JOKER1984]

Complete the correct template if you want help.

I did not understand why better explained to Italian English to me is hard to translate.
What should I complete?