Corona v4 blue wire.

[syswind]

Please give me the soldering point blue wire on corona v4.
I read and see a lot of tuttorial.
Wich is the best soldering point.

 

[BL4K3Y]

Use C5R11 like the instructions tell you.

 

[syswind]

Ok!
I' installed the dgx. Try cpu 10cm, postout 10 cm.
Nothing happened about 10 minutes.

What is the swich setting on dgx for corona v4?
switch 8 ON or all switch ON?

Please any instruction.

 

[modguru]

only switch 8 on rest off

 

[syswind]

Any instruction?
postout now 15cm.

 

[modguru]

blue wire must be 8 cm and yelow wire must be 55 cm

 

[syswind]

blue is 8 cm and yellow 55cm.
nothing happened.
Hom much time need to bott if i've a good settings?

 

[modguru]

ftom 10 sec to 20 min

 

[syswind]

Xell not booting. Tried a lot of version.
I'm use TX monitor cable. It's good or use HDMI cable?

 

[Martin C]

you still need an AV cable connected.

 

[syswind]

-this corona not booting.
Tried:
CPU RST 10cm outpost 10cm
CPU RST 10cm outpost 8cm
CPU rst 10cm outpost 55cm
Cpu rst 10cm outpost 84cm

Any idea?

 

[syswind]

Please check my installed wires.
It's seems good?

---------- Post added at 18:59 ---------- Previous post was at 18:59 ----------

 

[modguru]

this is not the right setup you have the blue wire tooooo long for cpu reset point D .. corect it capture a new image with the new install and post it again ..

 

[syswind]

---------- Post added at 20:16 ---------- Previous post was at 20:12 ----------

---------- Post added at 20:22 ---------- Previous post was at 20:16 ----------

Can i use slim post qsb on corona?