I am installing the DGX to my Corona V4. I installed the Post out and the R/W nand kit but when I go to read the nand it doesnt show the device. My soldering is fine any suggestions?
Last edited:
Corona V4 Nand Issue
- Thread starter crazed-cracker
- Start date
The console shouldn't power on if you have the switch on the adapter set to R/W.
It's hard to tell if your soldering is good or not because those images are blurry.
It's hard to tell if your soldering is good or not because those images are blurry.
jligg
VIP Member
I had one do this to me tonight. It was the ground on the rw board. I checked with a scope and the ground had perfect connection but device wasn't detected on pc. I soldered a wire from the ground on the board to another ground and it detected it instantly
Sent from my ADR6400L using Tapatalk 2
Sent from my ADR6400L using Tapatalk 2
Those Corona v4s can be a real pain in the a$$.
Try rebooting your laptop,plug in the sd card with ribbon cable attached/set to r/w.
Then open your JR in admin mode.
It should detect the sd card.
In some occasions you may want to try a sd to usb converter and see if that shows any difference.
Always check your soldering and try to get a better picture.
Something a little more clearer.
Try rebooting your laptop,plug in the sd card with ribbon cable attached/set to r/w.
Then open your JR in admin mode.
It should detect the sd card.
In some occasions you may want to try a sd to usb converter and see if that shows any difference.
Always check your soldering and try to get a better picture.
Something a little more clearer.
jligg
VIP Member
That soldering is ruff from the pictures i seen..you might have lifted a pad or something under the rw board. Those are extremely sensitive .
antonio010
Senior Member
That soldering is pretty poor. I would touch up and use flux. Then verify continuity with a multimeter.
Trust me the pictures make it look bad. I didnt clean the flux off yet. I know for a fact my solderings fine
Ya i have tried two
---------- Post added at 18:36 ---------- Previous post was at 18:27 ----------
Now when I go to turn the xbox on it just makes a sound but the fan doesnt spin and it doesnt turn on. I am keeping this as a stock console so I dont need to read the nand anymore. Why wont it turn on
jligg
VIP Member
Remove both if the console is going to remain as it is.
However, having the POST fix adapter installed won't affect normal console functions.
Last edited: