Corona v4 nand problem

laky97

Noob Account
Nov 1, 2012
4
1
Hi
sorry for my bad english
I have a problem with . First I installed corona 4gb QSB reader but I forgot to jumper R2C7 and R2C6, I inserted the card and nothing. Now when you turn on the console hear a beep just will not start, will not read nand because the PC does not recognize the card.
can be repaired
 

Brickmii82

Junior Member
Mar 19, 2015
20
0
Arizona, USA
Ok lets go step by step.
1. Did the console boot before install?
2. Where is the pic of the install? That's a picture of a motherboard
3. Did you look at any 4gB Nand r/w tutorial?
4. What order did you plug in the components? (the way I do it is card reader into comp, then power plug into 360.)
5. Since removing the QSB, does the console boot now?
 

laky97

Noob Account
Nov 1, 2012
4
1
ok
1.Yes
2.I have no picture
3.Yes, but not enough as soon as I made such a mistake
4.I do not know I did not pay attention
5.no nothing
 

Brickmii82

Junior Member
Mar 19, 2015
20
0
Arizona, USA
Looks like you've damaged one of the NAND pints. It will have to be repaired.
That's what I was thinking from the pic he posted. As I'm just a beginner I didn't want to say it though. It's the point on the bottom row of points, 2 in from the left. In between it looks like the trace is gone. Am I correct?
OP should definitely fill out template and take pics of the NAND RW kit to verify he is genuine TX product.
 

Krafter

VIP Member
Apr 17, 2011
3,737
118
Indiana
That's what I was thinking from the pic he posted. As I'm just a beginner I didn't want to say it though. It's the point on the bottom row of points, 2 in from the left. In between it looks like the trace is gone. Am I correct?
OP should definitely fill out template and take pics of the NAND RW kit to verify he is genuine TX product.
Yes. Damage to any of those points will cause the behavior that he's experiencing.
 
  • Like
Reactions: Brickmii82