CORONA corona v4 trouble with glitching and booting

[stucknvegas]

What do you mean no bridge
does the debug green light work
yes wire from K-pad to motherboard next to Red 5.5 wire on the motherboard

 

[appokruznz1028]

i mean by no bridge meaning no no default , no 10 ohm or no 100ohm , the debug light works just glitches and glitches and glitches and never boots into xell so i can retrieve the cpu key

 

[Krafter]

Why not put the jumper on default? I haven't tested it but I'd say that the jumper has to be on one of the three settings to work.

 

[stucknvegas]

no post bit never gonna cycle any settings--- that needs to be jumped preferable default
I see a small wire or something for post bit already hard to tell with the picture

 

[appokruznz1028]

yeah i lost the little peice and the prongs missed up so i desoldered them and used a wire as the jumper

 

[Antalpromille]

Try the jumper at default position, solder the C wire to pad 5 on your post fix and make the wire as short as possible. Then try cycling trough the dips.

 

[stucknvegas]

When he said cycle the dips keep 8 on and change dip 1-6 one at a time

 

[nofeloniesyet]

Try the jumper at default position, solder the C wire to pad 5 on your post fix and make the wire as short as possible. Then try cycling trough the dips.

^^ and watch ratar each time for changes.if it changes in any way ur on the right path usually.once you have the right dip combos set you will start seeing more and more in ratar.

 

[appokruznz1028]

ok so is there any way to see a real board picture of the cr4 , since i removed the prongs because i lost the little peice i forgot which one is default and others , im sorry if this is a dumb question but looking at the tut i cant tell which one is which unless there is a real pic please

 

[stucknvegas]

The post 0 or default is the one close to the R12 resistor

 

[appokruznz1028]

ok so i got it to finally boot xell but only once so i have the built a boot image and still nothing , but now the e pad wire came off of the board and now i cant solder it back on so looking for a alt point for e on the corona v4 wire , but even b4 the wire came off the point it would not boot again

 

[stucknvegas]

Booting Exell Thats really good now lets work on Alternate E point on the motherboard
I seem to remember a post someone made about that topic
Lets look around the forums PS I will look at a motherboard as well

 

[stucknvegas]

found it on google https://www.dropbox.com/s/48m5acknytiu6zq/altdb2g3.jpg?dl=0
use the largest white Square!! Also I tested it with meter
Dont worry about not starting with glitch image fix the wire

 

[stucknvegas]

You may want to Route the wire under the motherboard through one of the holes in the motherboard maybe by the south bridge

 

[Mode-B]

ooops my bad

 

[appokruznz1028]

with no more help i have now moved on to the next board , i need some type of help on this one with timing , so thank you for all the help that i have gotten from those who have helped