I've bought a new xbox 360 E 500Gb 1 month ago.
When i opened it i discovered that it's a stingray with no Post-out point.
But with a Postfix adapter i've solved this problem.
Closed the three missing resistor, and soldered the CR4.
Dumped the nand 4 times, alway the same without errors.
Create an ECC for Corona and CR4, flashed, but the console doesn't start.
The chips makes glitches every 5 seconds for less than 1sec. Forever.
I've controlled all the solders, before without a QSB, then with it. But no fortune.
If i write back the original dump, the xbox starts normally, withous disconnect any wire from the chip.
Here's some screen:



The dashboard is 17150.
Nand 16Mb
Programmer used are Nand-x before, jpr v2 after.


Sorry for my english.
Cupidz
When i opened it i discovered that it's a stingray with no Post-out point.
But with a Postfix adapter i've solved this problem.
Closed the three missing resistor, and soldered the CR4.
Dumped the nand 4 times, alway the same without errors.
Create an ECC for Corona and CR4, flashed, but the console doesn't start.
The chips makes glitches every 5 seconds for less than 1sec. Forever.
I've controlled all the solders, before without a QSB, then with it. But no fortune.
If i write back the original dump, the xbox starts normally, withous disconnect any wire from the chip.
Here's some screen:



The dashboard is 17150.
Nand 16Mb
Programmer used are Nand-x before, jpr v2 after.


Sorry for my english.
Cupidz
