that as made me so happy mate thanks, now get off my back fatty you are too heavy lolafter 850+ posts its nice to see you finally made a useful one, you get a star!
Last edited:
[Corona V5] Help with Stingray and CR4 XL won't boot
- Thread starter cupidz
- Start date
why would you want to do that , have you tried loading the ecc into source manually then write it
if you have installed it all correctly now and tried all dip settings and jumper settings , the only thing you can try is another cr4 if you have one or alt chip
have you checked your post fix to make sure it is seated correctly , if it is tried different points with your yellow wire
Last edited:
its not a new point its just direct to post out , its just a case of trying every possible dip/jumper etc , too many people do the install try the settings as per tut then panic and start a thread saying it wont boot
one more thing , keep your wire as short as poss as well go from the chip straight across to the point not a detour around the board then to the point lol
Tested the other point on post adapter, keep the wires as short as possible, created ECC with WB, WB4G and none, used the alternative point under the clamp, but non success.
If i try a CR3 Lite, is there a particula file for program the chip?
Sorry for my inconvenience.
they are not pre programmed,
To OP: cr3lite(nofelonie) sucks d**k, not sold or made anymore by TX you most likely have a clone chip if u want support once u put a cr3lite in your console then post up picture of said cr3lite to verify its legitimacy.. otherwise do not bother asking..
OP : did u ever bother putting E where its recommended to go on db2g3 ? where u have it might look fine to a MM , but it could also be behind a cap/resistor in the series.. db2g3 works and is what is recommended
Last edited by a moderator:
With a Cr3 Lite the console starts in max 4 cycle.
I don't know what's the problem about this CR4 XL
I don't know what's the problem about this CR4 XL