Hello, this is my personal corona V6 board that I was trying to read and write the nand of but won’t be recognized by any computer I have. I am experienced in soldering as I repair and offer modifying services locally but never had a problem with a TX Corona 4GB R/W V4 before. I have tried multiple card readers, including one that is said to work from previous consoles, and multiple adapters. Below is the clearest picture I had of when the TX Corona 4GB V4 qsb was soldered in place, this may not be the best but none were bridged. I have tried bridging 4 & 6, bridging R2C6 & R2C7, and also directly soldering to a micro SD adapter and to a card reader. Still nothing worked. Before posting here I have read multiple posts and looked through the pages in this section to see if I've missed anything but no help. If anyone could help me solve this, it'd be greatly appreciated and good for the future if I have this problem again.
