Corona v6 will not power up after reading the nand

[BigHomey]

I read the nand successfully now the unit will not power up. At first I thought I may have torn the faceplate ribbon but I ruled that out by trying to power up with a corded controller. I will put up some pictures later however the only thing I did was solder in the QSB. Any similar experiences or a fix would be appreciated.

Thanks

 

[john mathews]

http://team-xecuter.com/forums/showthread.php?t=96474more then likely u may have torn a trace or have a bridge somewhere we need pics of install and fillout template

 

[BigHomey]

I took the QSB out and the power light would come on and go right out. The unit would not boot until I replaced the disk player. Maybe this is common? Already installed the post out. Proto v2 next. Hope this helps someone.