Corona won't boot to Xell

[amarzano42]

Ok so basically this is first time installing postfix. I tried on another corona with same results. It just wont boot to xell after everything I tried. I double checked soldering and postfix. Tried a different cr4. Cr4 doesnt make the low buzzing noise when glitching I heard on the other trinity I successfully did. Thank you for taking a look.


Console Type: Corona v3 (I believe)
Programmer Used: JRP v2.0
NAND Size: 16
Dashboard version: 17349
CB Version: 13181
Screenshot of NAND details from J-Runner: https://imageshack.com/i/p8UK7U73j
Images of close-up soldering to motherboard (attach images to your post)
https://imageshack.com/i/f0BQ5rUaj

https://imageshack.com/i/ipcTjAw9j

https://imageshack.com/i/f0Vc2J5qj

https://imageshack.com/i/p7VMbu4Xj

https://imageshack.com/i/eyJx2qavj

https://imageshack.com/i/ipJRCjOaj

https://imageshack.com/i/f0GkxsvSj





Was the console working before you started: Y
Do you get a green debug light appear on the CR4 XL chip every 4-5 seconds: Y
How long is the light on for each time a couple seconds, no sound when trying to glitch





Jrunner Log:


No internet connection found (RasInstalled), so can't check integrity of files. Use at your own risk
===================================================
Monday, July 20, 2015 2:34:58 PM


J-Runner v0.3 Beta (7) Started




WARNING! - Your selected working directory already contains files!
You can view these files by using 'Show Working Folder' Button


Version: 10
Flash Config: 0x00043000
00043000
Corona
CB Version: 13181
Corona
Reading Nand to C:\Users\John Rogers\Downloads\J-Runner v3 (5) Core Pack\J-Runner v3 (5) Core Pack\output\nanddump1.bin
Reading Nand
Error: 250 reading block 3E0
Done!
in 3:21 min:sec


Reading Nand to C:\Users\John Rogers\Downloads\J-Runner v3 (5) Core Pack\J-Runner v3 (5) Core Pack\output\nanddump2.bin
Initializing nanddump1.bin..
Corona
Glitch2 Selected
Nand Initialization Finished
Reading Nand
Error: 250 reading block 3E0
Done!
in 3:21 min:sec


Comparing...
Nands are the same
ECC created
Version: 10
Flash Config: 0x00043000
Writing Nand
image_00000000.ecc
Done!
in 0:18 min:sec
Jrunner log:

 

[john mathews]

u want to check the cr4 box in jrunner ,

 

[GeekHeat]

What dips and postbit jumper settings have u tried.

 

[amarzano42]

Thanks bros. I will tick the cr4 and create a new ecc. I tried like 15 different combos already.

 

[john mathews]

also make the cpu rst wire short as possible/also clean cpu rst area up and trim the wires down, looks like solder droppings

 

[amarzano42]

So I tried to write new ecc and now the xbox wont even turn on. I cant read or write back to the nand either because jrunner is not finding the xbox. Power hooked up only of course. At first it did pick up the xbox, but after trying to write the ecc again it wouldnt pick it up. I think its fried.

 

[joshypoo]

are you sure your soldering is good on your nand leads? please post pictures of them