RGH CoronaV3 NAND unreadable!

[Argentum]

I am working on a CoronaV3 and the nand just refuses to read the console is working well.

I am getting
Flash Config: 0x00000000
Can not Continue

With both NAND-X and JR-Programmer

-The power supplier is plugged console off.
- I tried different wires and USB cable
What else can I do?

 

[tattoome25]

Give this a try it looks like the you need to bridge your r2c10 on your first picture in the official corona mother board verification chart it says you need to bridge r2c10 on v3 corona(for nand r\w) and then bridge r2c6 and r2c7 to make the cool runner work and you will find these on the j2c3 header(your first pic)

http://team-xecuter.com/forums/showthread.php?t=96752

 

[venenodcuba]

Give this a try it looks like the you need to bridge your r2c10 on your first picture in the official corona mother board verification chart it says you need to bridge r2c10 on v3 corona(for nand r\w) and then bridge r2c6 and r2c7 to make the cool runner work and you will find these on the j2c3 header(your first pic)

+1

 

[Martin C]

In other words, RTFM.

The information was posted in that thread for a reason.

Don't forget that your POST_OUT won't be wired up.

 

[Argentum]

I already placed an order for some Postout fix
I read that thread the day it was made. I totally forgot that anything has to be done in order to read the nand. That's why I did not look again.

My mistake anyway I have a bad memory.
Once I realized that I felt like :facepalm:

I just googled RTFM
rtfm
Abbreviation
vulgar. Read the f**king manual (used esp. in electronic mail in reply to a question whose answer is patently obvious).