i have a falcon board that had the cpu swapped with an exploitable cpu and nand. the xbox boots fine and everything, i have used the boxxdr method and am using wires on my nand x to dump the nand and i get the could not detect error.
these are new wires i ordered for the nand x. i have done 20 jtags in the past, i rebuilt the J1D2 before on another falcon.
anyways the wires and i resoldered them 3 times, tested them on another 2 consoles.
just to be safe i rebuilt the J1D2 on this board, while i was doing so i noticed the component that the yeller wire on this pic connects to was not on properly
http://www.dports.me/Xmods/J1D2_bottom.JPG
possibly it moved during the reflow/ reball. i fixed it and soldered the wire to it and did the rest.
i still get the same error. i just jtagged a box 20 mins ago, but this console is crapped.
these are new wires i ordered for the nand x. i have done 20 jtags in the past, i rebuilt the J1D2 before on another falcon.
anyways the wires and i resoldered them 3 times, tested them on another 2 consoles.
just to be safe i rebuilt the J1D2 on this board, while i was doing so i noticed the component that the yeller wire on this pic connects to was not on properly
http://www.dports.me/Xmods/J1D2_bottom.JPG
possibly it moved during the reflow/ reball. i fixed it and soldered the wire to it and did the rest.
i still get the same error. i just jtagged a box 20 mins ago, but this console is crapped.