Hey guys, was hoping to get some quick advice. I have a trinity xbox slim board with coolrunner installed. I have the green light blinking on the CR but not booting to xell. Should I rewrite the timing file to the CR, or should I be looking for a physical issue like soldering. Thanks in advance!
RGH CR blinking green, no boot to xell
- Thread starter Doowatchyalike
- Start date
reefz3ro
VIP Member
post pics of the install top and bottom side of mother board
my guess is the way your CPU_RST wire is routed but with out seeing anything it could be anything
my guess is the way your CPU_RST wire is routed but with out seeing anything it could be anything
reefz3ro
VIP Member
try your putting your coiled up CPU_RST wire under the xclamp and boot to xell
Hmm.. same behavior. Green light blinking still no boot to xell. Loosened up the coil a bit and tucked under the x clamp.
reefz3ro
VIP Member
cj_goalie31
VIP Member
how quick is you green light blinking if its blinking super fast then its probably soldering ive had that problem before but if its not make sure you use multibuilder or the new j-runner to make your ecc image file.
cj_goalie31
VIP Member
At the risk of sounding like a total noob, where can I find Jrunner?
Also yes, I got three matching dumps.
Also yes, I got three matching dumps.
oO Elite Oo
VIP Member
Wrote nand with J-Runner (awesome program). Same behavior. Tried booting with both eject and power button. This is not my video, but the same symptoms:
[ame="http://www.youtube.com/watch?v=xviaptgUd4M"]RGH not booting into Xell. - YouTube[/ame]
Thanks for your continued support!
---------- Post added at 16:42 ---------- Previous post was at 16:39 ----------
I also verified it boots on factory Nand
[ame="http://www.youtube.com/watch?v=xviaptgUd4M"]RGH not booting into Xell. - YouTube[/ame]
Thanks for your continued support!
---------- Post added at 16:42 ---------- Previous post was at 16:39 ----------
I also verified it boots on factory Nand
I am having the same issue as this no matter what it wont boot, I am sending mine to some one soon as soon as I get money and hehe you used my video 
@Freake, that is super ironic. I'm confident the issue can be resolved, I'm just looking for direction here instead of working in circles like I was doing. The guys on here are extremely helpful.
If you have a REV B cooler runner you could try bridging the CAP point on it, my jasper only yesterday was refusing to boot even into xell, after bridging that point it came straight on...
He hasn't got a fat so the cap won't help. Get the blue wire clear of the board completely and try. Doesn't matter whether you press eject or power the ecc only boots to xell so it makes no difference which you press. Check over your soldering again and you can try flipping the swwitch on the coolrunner from slim to phat as some say it can make a difference.
Failing that come back.
Failing that come back.
reefz3ro
VIP Member
Looking at your pics again the POST_OUT1 point on the underside of the board look very damaged that may need to be repaired before it will boot.
I dont know enough about damaged points so someone with better knowledge will have to answer that.
I dont know enough about damaged points so someone with better knowledge will have to answer that.