RGH CR blinking green, no boot to xell

[keil423]

Your next step would be to write the retail nand back to see if it still boots up. If it doesnt boot up on the Retail nand then the problem is with your soldering. I'm betting that you have damaged the CPU_RST point (FT4R2). If this is the case on stock nand it should red dot on you.

 

[Doowatchyalike]

Uncoiled the CPU reset and moved it away from the board. I've reviewed (and redone) my soldering. I toggled the phat/slim and that didn't make a difference.

---------- Post added at 17:49 ---------- Previous post was at 17:42 ----------

Boots fine on factory nand. Thanks for the suggestion though!

 

[Doowatchyalike]

I have killed my boot in the process of redoing my points... It will no longer boot with retail Nand. Possibly seeking professional help to recover. Any suggestions appreciated.

 

[dronecz]

Hi, I had same problem with my RGH on slim. I thought that my problem is soldering so I tryed re-do all of the cables and now my xbox just "ding" and is not booting at all. Also my Nand-x cannot find Nand controller :-(.

I´am just wondering if you have same problem?

 

[freake]

What points have you broken, I may be able to tell you how to fix it.

 

[dronecz]

That is the problem. I can´t find anythink broken :-(. I checked resisitor and it shows 33 ohm and also trace is good for STB_CLK (tested to the nearest point and also to the other side of the mobo).

I find this tread :
http://team-xecuter.com/forums/showthread.php?t=76145

where is alternative point for CPU_RST which give me no conection with multimetr between CPU_RST point and that resistor (R4D4) which I guess should be connected.

My board is just simple dead :-(.

Do you have any sugestion?

Many thanks for help.