CR help again.

[johnny429az]

It doesn't want to program. Its been flash before for a jasper but kept getting rrod so im using it on a TRINITY now. Switch is on program. Could it be that I removed the 1 position resistor for the jasper.

 

[WildCard007]

You need better pictures and rotate them so they can be seen without head having to tilt. Other than that it looks like you've abused your coolrunner. What are the loose wire looking things attached to the pins at the bottom of picture 2?

 

[johnny429az]

Update got it to program but its really slow over thirty minutes now still program. Red and green light on.

 

[ablegepu]

did you already program it once to another xbox? and how long did it take then? 30 minutes is WAY too long..

took another look and like WildCard said it does look like you have something on the prongs possibly shorting the tdi tms pins

 

[johnny429az]

Finished took 1 hr

 

[ablegepu]

check the prongs dude it only takes a few seconds to program a coolrunner

 

[johnny429az]

I know it takes a few seconds. Im thinking about not putting it in my slim. Dont want to install it and it not work

 

[ablegepu]

if you have to go over it with a fine toothed comb clean it with alcohol and a cotton swab until it looks brand new (aside from pad c missing) then check those prongs on the bottom of the cr where it says TX COOLRUNNER and make sure it has nothing shorting out pins adjacent to them. then rewrite the trinity xsvf file

 

[Slayertex6]

Put some flux on the points of the pinheader (the prongs that the lpt cable attatches to), and reflow them (touch them with the iron), then try again.

 

[johnny429az]

Everything worked just long boot time. Thanks for the help. Close post