RGH CR rev c with Falcon

C

caver99

VIP Member
Dec 16, 2003
179
23
Ellesmere Port
I have a falcon with CB_A 5774 and CB_B 5774 which rgt would be best to use?

I have the following:

Falcon main board
CR Rev c with white wire on top of board
V2 qsb
Nand-x qb
the console had a bad update and wont finish update so trying to flash nand but need key but no matter what i do rgh1 ecc or rgh2 ecc
cant get pic from system when flashed and switch on norm and press power or eject, if i flash original nand back i can get to same update fall screen.
 
Last edited:
C

caver99

VIP Member
Dec 16, 2003
179
23
Ellesmere Port
had toi give up for time being as has ram problem 0220 or something so will probibly remove and place into my known working falcon with dad benq drive as logic board is dead on it.
 
C

caver99

VIP Member
Dec 16, 2003
179
23
Ellesmere Port
its ok i have worked out whats wrong with the install i am using the wrong QSBs i have the ones for the RGH1 not the RGH2 DOH!!!!

Update

but just looking on hare at the graph about the versions look like i need r-jtags for the consoles oh well have to leave them for now till i get can buy some dam.
 
Last edited:
chase

chase

VIP Member
Apr 11, 2004
1,073
28
Toronto, Canada
restore console to stock firmware, perform the update, use stock console until CR4 is released :)

if dvd drive is original one, may need to restore it to stock fw for update to finish(depending on dash version before update)
 
nofeloniesyet

nofeloniesyet

VIP Member
Jan 16, 2011
4,830
128
Nowhere
caver99 said:
drive has not been modded an is stock i have put system update on usb but console dont look at it for some reason.
Click to expand...
make sure the update folder is spelled JUST like this : $SystemUpdate
 
You must log in or register to reply here.