CR3 lite oscillator got damged by accident .

[Neoglicher]

Hi every one here , I know its quite rare to give support to these kind of problems but i hope i can get some help because its hard to find a cr3 lite on sell these days , i just don't want to buy a clone .

So after installing my jasper's cr3 lite on a new console ( falcon v2) i tried to modify the S2 jumper settings with a sharp screw driver due to the very thin switchs , and by accident i pealed off the oscillator , and it was sadly broke , i have tried to re-solder it but nothing , i am afraid i may also broke the pcb traces .

So right now am thinking of buying a new oscillator , am wandering if there is a possibility to get one with higher frequency than the retail one ?
Also if possible whats the best setting for a falcon to have nice boot times ?

 

[playingmax]

post a pic

 

[playingmax]

fyi, u dont need the oscillator for rgh 2. u could even use a cr rev c.

 

[Neoglicher]

fyi, u dont need the oscillator for rgh 2. u could even use a cr rev c.

Why not , oscillator is needed for the xilinx to work ., i think i will get one just like on chip .

Can you help out on falcon jumper settings ?

 

[ultimate360]

Why not , oscillator is needed for the xilinx to work ., i think i will get one just like on chip .

Can you help out on falcon jumper settings ?

You honestly don't need the oscillator, I'ts disabled when the switch is set to phat and bridge LK1 anyways. Try this config for your lite in a falcon:

Start with falcon file, then go through the list and see what works best.
LK1 - Short (Disable Crystal)
LK2 - Open (Enable 10 Ohm on CPU_RST)
LK3 - Open (Disable C15)
LK4 - All Open (Slim Settings)

S2 1&5 on

Still upload a photo of the damage to make sure you didn't hit anything important

 

[Neoglicher]

Okey , i have completely removed the oscillator and recovered a bad track .

But the problem is i have really hazardous boot times , sometimes the glitch boots in about 3 to 5 seconds , but most times its 2 or 3 minutes , sometimes not at all, sometimes ithe dot flashes and then glitches .

 

[playingmax]

That means ull have to mess around with cpu rst wire sz

 

[ultimate360]

Have you done some playing around with the timing files?

 

[Neoglicher]

Currently using the falcon rgh 2 file .

BTW after flashing the nandwith the updtflash .bin , when the console boots , the middle dot led stays in blinking mode , is it safe to let it like that ?

 

[Sasuke Uchiha]

if your middle light is blinking its becuase of your dvd drive not being connected or not getting a good connection

 

[Neoglicher]

if your middle light is blinking its becuase of your dvd drive not being connected or not getting a good connection

I solved this , thanks .

Now i have another problem the console gives random shut downs while playing a game for about 10 minutes or copying a game .

 

[playingmax]

I solved this , thanks .

Now i have another problem the console gives random shut downs while playing a game for about 10 minutes or copying a game .

dont just say thanks. dont forget to hit the thanks!
n about ur console check ur dashlaunch setting. .

 

[Neoglicher]

dont just say thanks. dont forget to hit the thanks!
n about ur console check ur dashlaunch setting. .

Hi again .

Before configring dashlaunch i will first change the thermal paste i put , i hope i will get some good temps , i will resolve that crashing problem later .

My temps are ( in celcius , FSD & xexmenu) :

58 : CPU
75 : GPU
75 : RAM

As for the glitch boot : am right now between 15 seconds and 1 minute , i think my glitcher is starting to adapt with the console .

 

[nofeloniesyet]

Hi again .

Before configring dashlaunch i will first change the thermal paste i put , i hope i will get some good temps , i will resolve that crashing problem later .

My temps are ( in celcius , FSD & xexmenu) :

58 : CPU
75 : GPU
75 : RAM

As for the glitch boot : am right now between 15 seconds and 1 minute , i think my glitcher is starting to adapt with the console .

those times are bout as good as it gets with a reg glitcher on rgh 2.0

 

[Neoglicher]

those times are bout as good as it gets with a reg glitcher on rgh 2.0

But that so hot , do you mean even with an arctic silver , i'll still have those temps ? what are the normal temps for a non-glitched falcon ?

 

[nofeloniesyet]

But that so hot , do you mean even with an arctic silver , i'll still have those temps ? what are the normal temps for a non-glitched falcon ?

my previous comment was referring only to your boot times,not temps.

 

[Neoglicher]

my previous comment was referring only to your boot times,not temps.

Sorry .