FIXED CR3 Lite + RGH2 Falcon

[blindgirl]

Hi.

Basically im a bit lost with the RGH2 CR3 Lite + Qsb's setup.

What i figured out so far is that im suppose 2 use Rev c wiring route for RGH2. But according to this http://team-xecuter.com/forums/showthread.php?t=86539 thread and pictures in it im suppose 2 solder F wire to qsb's, but on the the qsb's i have there is no F point at all. Not to mention the green and blue cables are gone from the back of the motherboard.
Could any1 point me into the right direction here ? Thank you.

 

[BL4K3Y]

It sounds like you have the older RGH1 QSBs.

In which case, solder the E & F wires to the underside of the board (they are through-hole points).

 

[x360ccm]

just post images of your install,as it is a must have..

then you'll get better help:wink:

 

[cj_goalie31]

Also you dont need the green wire for rgh 2 and the blue wire was moved to the other side of the board to reduce interference but you can also try underside like rgh 1. Its really based on your console which wire route will work better.

 

[blindgirl]

It sounds like you have the older RGH1 QSBs.

In which case, solder the E & F wires to the underside of the board (they are through-hole points).

Thx for reply. Used your advice and everything went smooth as usual
Now to play with wires/routing/timing files to reduce glitch time.

Thx to everybody who reply'd, really appreciate the help.

 

[blindgirl]

just post images of your install,as it is a must have..

then you'll get better help:wink:

Id post the images if i had trouble with glitching etc. Since i was just a bit lost with where to solder the wires, i didn't bother with images.

So that you don't think that i ignored your post m8

 

[blindgirl]

Some info id like to share.

Just did 4rd Falcon RGH 2 for today and used the same settings for each of them:

Was using CR3 Lite.
Jumper settings as stated in the CR3 Lite jumper official thread.
Timing file A.
Used low loss cable(grounded).
Used 2 points for E and F under the motherboard.
Switch set to Slim.
CPU RST Clener's switches 1 and 5 ON, rest Of.
PLL_Bypass switch 1 ON, rest Off.

Boots in 2-3 cycles all 4 Falcon's(Dash 14719).

Hopefully some one can have their glitch times lowered by using this method.

 

[BL4K3Y]

Boots in 2-3 cycles all 4 Falcon's(Dash 14719).

Hopefully some one can have their glitch times lowered by using this method.

If by "cycles" you mean DBG LED flashes, leave things as they are.

Those times are good for Falcon RGH2.

 

[blindgirl]

If by "cycles" you mean DBG LED flashes, leave things as they are.

Those times are good for Falcon RGH2.

Yes m8. The green DBG Flash.
The timing is really good so far using the exact same setting for different console's.
Thats why i thought id share what settings i used. Might help some one in long run

 

[Zeppelins2]

Helped me big time, everything is all good now on both my Falcon's. Thank you very much blindgirl.

 

[Xalcker]

Just tried this configuration on a RGH2 Falcon, and worked, I get 4-6 cycles to boot, Thank you.

 

[MiguelSC]

After trying lots of different wire placement and switch settings, this solution worked fine.