CR3 Lite to CR4 upgrade tutorial

[kad786]

Hi,

Does anyone have any information or a tutorial on how to go about changing a RGH1 with CR Rev.c or CR3 Lite to the quick booting new CR4 XL 5 wire install.

My booting is usually about 15 sec, but reboots can take a lot longer or fail entirely. Hoping CR4 will improve it.

I have a Falcon, and a Jasper

Falcon: Dash: 2.0.9199.0, CB:5771, Have Original Nand Dump, R6T3 replaced with 10K

JasperBB CB:6750 Dash updated to 16747, no Original Nand Dump

Thanks.

 

[Antalpromille]

Of what I understand you don't need to be on a split CB to use RGH2+, so desoldering the old CR, solder the new CR4 in place and make a new image setup for glitch2 and don't forget to check the CR4 box also.

 

[Utmad]

Of what I understand you don't need to be on a split CB to use RGH2+, so desoldering the old CR, solder the new CR4 in place and make a new image setup for glitch2 and don't forget to check the CR4 box also.

Yes you would only need to update the dash to use RJTAG