I just installed the CR4 and QSB with JR-Runner successfully on my Trinity board and I was able to read the NAND X2 and I wanted to know if I need to backup the CPU key? If so how do I get the CPU Key? Or can I just run the TrInity .ECC and boot up the Xbox and get it that way? Not sure what to do at this point any advice would help.
ANSWERED CR4 install CPU Key
- Thread starter Jimz591
- Start date
A lot of people don't even know that manual exists. It would be nice if there was a shortcut for it within JR itself.Also the jrunner pdf has a nice step by step instruction. Easy to follow.
When you get to Exell If you have a Ethernet wire plugged into your Xbox you can use the scan IP function in Jrunner
Jrunner will grab all the Information and combine and save it in one folder after you make your first Hacked Image
Jrunner will grab all the Information and combine and save it in one folder after you make your first Hacked Image
Thanks guys I was able to boot up to Exell and get my CPU key. Sorry I'm some what of a noob but what do I do next? its trying to find TFTP. Also before loading the ECC I checked the RGH2 and CR4 in jr-programmer and used the Trinity.ECC provided below.
This is what I used:
CR4 XLT install - http://team-xecuter.com/forums/showthread.php?147878-Xecuter-CR4-XL-Magic-SMC-Files-for-RGH2
This is what I used:
CR4 XLT install - http://team-xecuter.com/forums/showthread.php?147878-Xecuter-CR4-XL-Magic-SMC-Files-for-RGH2
look in the jrunner folder and find the j-runner userguide .pdf file and follow that it will show you the way.:wink:Also the jrunner pdf has a nice step by step instruction. Easy to follow.