Cr4 not glitching

[willstrz]

Hi. I just got my CR4 xl and jr prgrammer today. I have already read the nand, compared them and they are the same. i wrote the ECC, selected CR4 and Jasper 16mb. I soldered the CR4, put the postbit to 0, and turned the switch to phat, and changed the dip switch to all up except for 4 and 8. my soldering is fine, nand is fine, but something is wrong with the cr4, it blinks green and holds for 5 seconds inbetween then blinks 2 twice and the fan just spins up then down constantly, even though its not overheating. thanks.

 

[Taijigamer2]

That's how it's meant to behave when glitching. If u are not getting xell, u need to try all dip settings and post bit combos for your chosen glitch method. Please fill in complete template if u get any other issues.

 

[willstrz]

so what should i try? i have already tried all of the dip settings, but not all post settings.

 

[Taijigamer2]

If u have a jrprogrammer, please post your Rater log along with jrunner log and pics of soldering. This will help give a better picture of what is going on.