hi. as you may know in my other post, i screwed the ft6u7 point so i had to move on to the top of the board. soldering here: http://s9.postimg.org/fuspkv5bz/IMG_3296.jpg so i was able to verify that the connection in which i soldered to is connected to the post on the cpu by running a multimeter on the connection and a scrapped part that is the same wire and is right outside of the cpu. so, plugged it in, but im not getting any green light on my cr4. i am doing a rgh2.0 here, i have already read the nand, compared them and they are the same, i have wrote the ecc to my jasper 16 mb and it was successful. do you guys think i should hot glue the new post to the board? thanks.
JASPER CR4 not glitching!
- Thread starter willstrz
- Start date
Try to post us some other photos. If you aren't getting green light it's cpu_rst or post_out.
Also check if you switched cr4 switch to phat
Check if you selected correct .ecc there are two one for rgh2 and one for rgh2+ with cr4 chip.
Do you use correct dip switches?
I can't see it well on your photo, but if you measured that with multimeter it Should be good. But don't glue that yet. At least until you manage to get green light. Just in case. You can do more damage if you will need to remove glue
Try to post some other photos. I am just guessing what can be wrong.
Also check if you switched cr4 switch to phat
Check if you selected correct .ecc there are two one for rgh2 and one for rgh2+ with cr4 chip.
Do you use correct dip switches?
I can't see it well on your photo, but if you measured that with multimeter it Should be good. But don't glue that yet. At least until you manage to get green light. Just in case. You can do more damage if you will need to remove glue
Try to post some other photos. I am just guessing what can be wrong.
cr4 is switched to phat
glitch2 with cr4 ticked - jasper 16 mb
all up except 4 and 8
it is making connection
cpu_rst and cr4 here:
http://imgur.com/a/1iB9N
glitch2 with cr4 ticked - jasper 16 mb
all up except 4 and 8
it is making connection
cpu_rst and cr4 here:
http://imgur.com/a/1iB9N
your blue cpu reset wire is making contact with a capacitor which it shouldnt be doing.
be careful... you have bridged a point and if you arent careful you can do more harm than good at this point.
be careful... you have bridged a point and if you arent careful you can do more harm than good at this point.
Last edited:
it was not that point. i checked it, and resoldered it, but still no green light.
Taijigamer2
VIP Member
Please fill in complete template including pictures of all soldering. Does console boot on stock nand? If u are using jrprogrammer, please include rater log.
what template? the concole does boot with stock nand and my rater log has no errors so my ecc is fine.
Taijigamer2
VIP Member
http://team-xecuter.com/forums/threads/148057-TEMPLATE-HOW-TO-ASK-FOR-CR4-HELP
please also provide Rater/ postout log if using Jr-programmer. This will show straight away if your postout wire is correct.
please also provide Rater/ postout log if using Jr-programmer. This will show straight away if your postout wire is correct.