CR4 Reset Loop

[zcaps]

I have a CR4 installed with good soldering. It will boot the original nand just fine and take me to the dashboard, but it will not boot xell after I write an ECC. I'd appreciate any help I can get.

The only thing I can think of is that Jrunner does not support my CB Version.

TX Product(s) used: J-R Programmer, CR4
Console Type: Jasper
NAND size: 16mb
Dashboard version: e.g 2.0.16767
CB version: 6754
Screenshot of NAND details from J-Runner:
(attach an image to your post)
J-Runner log:

Checking Console..



Version: 10



Flash Config: 0x00023010


00023010

Trinity, Jasper 16MB
CB Version: 6754
Jasper 16MB
Initializing nanddump1.bin..
Jasper 16MB
Jtag Selected
Nand Initialization Finished
Glitch2 Selected
CR4 Selected
Jasper 16MB Manually Selected
ECC created
Version: 10
Flash Config: 0x00023010
Writing Nand
image_00000000.ecc
Done!
in 0:18 min:sec



POST OUTPUT:

CR4 Selected
Version: 10
Power Up
Waiting for POST to change
Post 13 - .........
Post 13 - .........
Post 01 - .
Post 03 - ...
Post 04 - BOOT SEQUENCE STARTING
Post 05 - ...
Post 06 - ....
Post 07 - .....
Post 08 - ......
Post 09 - .......
Post 0A - ........
Post 0B - .........
Post 0C - ..........
Post 0D - GLITCH CHECK COMMENCE
Post 01 - .
Post 03 - ...
Post 04 - BOOT SEQUENCE STARTING
Post 05 - ...
Post 06 - ....
Post 07 - .....
Post 08 - ......
Post 09 - .......
Post 0A - ........
Post 0B - .........
Post 0C - ..........
Post 0D - GLITCH CHECK COMMENCE

Let this go for 30 cycles and no boot

Results:
Overall: 1 / 20
Average: 32.00
Median: 32
Score: 0.00


Cycle 32 - 100.00%


100% within 32 Cycles




Was the console working before you started: Y

 

[GeekHeat]

We need pics of install and what dip settings have u tried.

 

[zcaps]

I'm using the default #15 dip settings 123 567 ON - 4 8 OFF
Using 10 ohm cap also.
Will post pictures soon

 

[GeekHeat]

I'm using the default #15 dip settings 123 567 ON - 4 8 OFF
Using 10 ohm cap also.
Will post pictures soon

U need to try different dips and postbit jumpers.
No point in trying default and that's it.
Default setting is just a guideline.

 

[nofeloniesyet]

all dashes and cb are supported,pls post pics of soldering.

 

[zcaps]

Updated Pictures

 

[zcaps]

Just pulled up the yellow wire and messed up the trace RROD 0010... yay