TX Product(s) used: CR4 XL, J-R Programmer V2
Console Type: Trinity
NAND size: 16MB
Dashboard version: 2.0.17511.0
CB version: 9231
Description of problem: Won't boot to Xell. First time modding a 360, but not my first time modding a game console. The soldering for the J-R Programmer doesn't look pretty, but it works fine. I dumped the NAND like 7-8 times and they all matched. Dumped the NAND, made an .ecc file and flashed it to the 360. The clip on the CR4 is used as a jumper because I lost mine (oops). I made sure it didn't touch anything else. I cut the wires short. Tried a few switches combos, tried a 22pF cap on C10, tried 0, 10 and 100 ohm on the jumpers. Don't know what else to try.
Was the console working before you started: Y
Do you get a green debug light appear on the RGH chip every 4-5 seconds: Y
How long is the light on for each time: ~200ms
Console Type: Trinity
NAND size: 16MB
Dashboard version: 2.0.17511.0
CB version: 9231
Description of problem: Won't boot to Xell. First time modding a 360, but not my first time modding a game console. The soldering for the J-R Programmer doesn't look pretty, but it works fine. I dumped the NAND like 7-8 times and they all matched. Dumped the NAND, made an .ecc file and flashed it to the 360. The clip on the CR4 is used as a jumper because I lost mine (oops). I made sure it didn't touch anything else. I cut the wires short. Tried a few switches combos, tried a 22pF cap on C10, tried 0, 10 and 100 ohm on the jumpers. Don't know what else to try.
Was the console working before you started: Y
Do you get a green debug light appear on the RGH chip every 4-5 seconds: Y
How long is the light on for each time: ~200ms
