TRINITY CR4 XL with VGA support?

A

aden34

Full Member
Sep 17, 2014
44
8
not sure if this is even the right spot to post in, but i am working on a 360 laptop and have the console installed with cr4xl (Trinity on latest dashboard) that boots up no issue with HDMI, almost instant boot everytime. anyways, i soldered the points from the consoles VGA (R,G,B, H/V Synce, Grounds for RGB H/V Sync, Use VGA) and the console still won't display anything. figured it was my soldering, so i went back and checked and it was good (good enough to pass lol)

anyways i noticed that the console glitches, but doesnt boot when trying this? are there any connections that i am missing for soldering? am i suppose to solder just R,G,B, H/V Synce, Grounds for RGB H/V Sync, Use VGA? will this even work with CR4 XL?

forgive me if this is in the wrong section
 
A

aden34

Full Member
Sep 17, 2014
44
8
BL4K3Y said:
Have you tried resetting display settings?
Click to expand...
well the issue is that the console does glitch, but doesnt actually boot. i can tell it glitched because the fan started to speed up a bit and the green light stopped blinking, but it doesnt actually boot the logo and i can't connect my controller to it either since the rol never even spun

however, the console does boot into xell. i can't get a picture, but it does do rol and then my controller can connect
 
You must log in or register to reply here.