ANSWERED Crashed - Cant Detect Drive

[II AnDo II]

Was restoring my Liteon DG-16D2S 02510C and jungle flasher crashed when writing bank 0 (screen shot)

Setup
USB Pro - CK3 Pro


Now it says in jungle flasher No Drive Detected

 

[Fisticuffs]

Load your target firmware then click liteon erase, And make sure to run JF as admin

 

[II AnDo II]

Thanks mate showed up after a pressed liteon erase

 

[koennoppe]

Hi , I have the same problem but with a DG16D4S 0225 can i also do the liteon erase thing or is it only for the DG16D2S ?

 

[nofeloniesyet]

Hi , I have the same problem but with a DG16D4S 0225 can i also do the liteon erase thing or is it only for the DG16D2S ?

doing an intro on it should also bring the properties up so you can do whatever u need to.

 

[koennoppe]

so you mean that i have to just intro en the properties would be back ? but i also had a problem before i succesfully installed the sputnik on my pcb and i unlocked it to 0x00 . I heard the beeps and did it then i tryed to write but it got stuck at writing bank 0 . any help ?

 

[nofeloniesyet]

so you mean that i have to just intro en the properties would be back ? but i also had a problem before i succesfully installed the sputnik on my pcb and i unlocked it to 0x00 . I heard the beeps and did it then i tryed to write but it got stuck at writing bank 0 . any help ?

so open a new thread with ur problem if intro dont work,cause technically ur hijacking the orig posters thread here,jus a heads up