d0 points

[gundam55]

is there anywhere where all d0 points are shown on all versions of the xbox? I belive i have a 1.5 but not 100% sure. I am installing a xapt3r and i think i have the correct d0 but it keeps showing red on the xapt3r. Thanks

 

[ozzy]

This website shows you also have a look at baldbouncer

 

[rodnutz]

First of all make sure you know what version xbox you have. Check out xbox-scene.com Here is what you asked for these pictures are from the xecuter 2.3 diagram but they show the d0 points for xbox version 1.0 to 1.5 the d0 point is the gray color. Good luck.

http://www.teamxecuter.com/23b/lite/1011_lpc_wires.jpg

http://www.teamxecuter.com/23b/lite/1215_lpc_wires.jpg

 

[MUTHAPHUQA19]

Ben-Q Jungle Flasher Question

I just used jungleflasher v0.1.76 beta to upgrade my benq drive to LT+ and when i was writing the banks i got a verified failed write instead of a write verified ok and when i read the firmware again LT+ was installed on my benq drive then when i tested it all of my backups and originals work just fine including NFS and ACBH patched.So s that a glitch in the new jf or is there something wrong?

 

[scasy]

Re: Ben-Q Jungle Flasher Question

couldnt hurt to try to reflash and see if you get the same result.