D0 wire install problems on solderless

[the gas man]

I'm thinking of trying to use an adhesive on the DO wire to secure it into the hole as it will not stay in. Any thoughts on this approach?

 

[matt77303]

should be good, make sure its in correctly before you glue it, if you were to have to be moved, glue is a bastard to get aoff a circuit board.

Matt

 

[the gas man]

I was thinking a gel super glue since it would allow me a little play before it sets.

 

[matt77303]

when i do installs i always use hot glue gun to hold down and wires, ie DO and the LED wires i cant see why hot glueing the DO point would be any different, go for it.

Matt

 

[batosai]

I was going to try hot glue but was afraid that the heat would mess with the board. I may try this since you've had success with it.

Edit: this is the gas man