Danm e79 error

[blazin6969]

Hey thought I would get everything working the first time but like always I fail. Ok, I read my nand before even installing the jtag, had a bit of a problem and I remember reading if you get a device error most likely soldering skills. So I went back and touched the solder points and this time ran a striped wire through to make sure solders flowed trhough.
Well got my nand everything checks out, then I installed the jtag got the e79. So I went back resoldered everything, reflashed back booted up just fine.
Now I flashed again with xell, still e79, change the setting on the qsb to 300 still e79 then to 400 still e79.
Was wondering if anyone can help me I feel like Im almost there just cant get past this part. I have a xenon board. I can just imagine a non xenon will be, I think next time Im going to use header pins. If that is the case what do I do when I get to the jtag portion?

 

[manwithoutname]

Your problem will be one of two:

1. Still bad soldering @ the JTAG points.

2. Bad blocks that needs remapping.

If you have trouble soldering then use wires and generic switching diodes 1N1481 to complete your JTAG part.

 

[blazin6969]

Alright think I might go the wire route, checked my nands none seem to have any errors so I guess my soldering was ok on the nand part correct? I'll search and see if I can find a diagram on wiring and the diodes on xenon board, thanks.

 

[manwithoutname]

 

[blazin6969]

Your problem will be one of two:

1. Still bad soldering @ the JTAG points.

2. Bad blocks that needs remapping.

If you have trouble soldering then use wires and generic switching diodes 1N1481 to complete your JTAG part.

Or is it this diode 1N4148? I took the qsb off for the jtag and I am going to try to hard wire with the alternate points likes in ur tut. I tried to flash to xbr injected my kv still e79...I got an e79 kit to might try that first maybe I was so lucky to have my first jtag to be a pain in the balls. Also I seen the bat41 diode however I think the qsb uses the bat41 diode and the e79 kit might use something more simpler.

 

[manwithoutname]

The 1N1481 diodes works perfectly, I have used them ever since I started jtaggin and they never failed for me at any time. The alternate jtag points have been tested on HDMI consoles only but come to think of it I don't see why they can't be used on xenon even though I really don't think it's necessary.

You might want to show us pictures of your install and soldering?

 

[blazin6969]

I'll post some pics on sunday, I removed one of the pads on the jtag when desoldering so I need to go alternate method now. Where can I get the 1N1481 diode. I can find this one 1N4148 and alot of users use that one but where is the 1n1481....
I was desoldering going to try the e79 kit I bought. And if not then diodes if I can find em. Thanks for your help by the way.

 

[manwithoutname]

Sorry, typo in the diodes code. It's like you said (1n1481). This where I get mine from, hey got a store that is just 2 miles away from me.

 

[sick360mods]

u can use ebay. thats where i got mine

 

[blazin6969]

Well for the sake of time I will pay $1.50 each at ratshak and order some on ebay as well. Im guessing these have polarity as well and need to be attached a certain wait correct?