LITEON DG-16D4S - SLIM Dash update and error code despite the flashed drive

[tseliot]

Hi all,

I was using Lt+ 1.9 then I decided to flash my Liteon DG-16D4S (9054) back to stock before updating to dashboard 13599 (from my usb key). The original firmware was flashed correctly.

The dashboard update failed despite the fact that my drive was flashed to 272 and locked.

This is the error code I got:

335A-351F-B600-0401-C000-0022

Of course I tried repeating the update from the usb key several times, pulling out the hard disk, etc. but nothing worked.

I decided to buy an unlocked Xecuter PCB to replace the original PCB and, thanks to my X360Usb pro, I flashed the new PCB to stock 9504, hoping that this would solve my problem and let me continue the update but I keep getting the same error.

Note: I didn't forget to set the SPI Lock Status to 0x8C or to set WP to 0 or to click the Outro / ATA Reset button afterwards in JungleFlasher.

Any ideas?

 

[chancer13]

what dash are you currently on?

There was a post on a site thro google that said that code was a firmware error??

pre 13146 will need 9504 firmware??

 

[Ubergeek]

This is answered so times not just here but a hundred different sites on google

Its so easy.

Simply flash your drive to stock 9504 fw and run the update using USB again.

If that doesn't work flash to stock 0272 fw and run the update using USB again.

Simple.