RGH Dead 360, after write nand

[jeno96]

Hello!
I am using J-r programmer and CR coolrunner.

I wrote ECC to falcon nand, and it showed the cpu key, i created the glitch and wrote with Error: 202 writing block 35D. Now it isnt turning on. I press power and nothing happen. CR led's are shining red. psu orange
When i try to write again the nand J-runner says:
Arm Version: 1
Flash Config: 0x00000000
Can not Continue
the psu is plugged in ofc. Reprogrammed J-R 10x

What can i do now?

THx.

EDIT: Now writing, my soldering was bad. But during the writing, J-R sometimes stops....


FIXED.

 

[doggyenterprisev2]

hey bro I have a jasper I rgh got the cpu key everything was fine console booted.. then when I click write nand it writed blah blah now console wont boot.. coolrunner is red psu is orange.. how did you fix yours? I will be removing the nand x wires once done have any ideas? Now when I want to write nand again it says
Flash Config: 0x00000000
Can not Continue

---------- Post added at 14:53 ---------- Previous post was at 14:51 ----------

how did you solve it please explain thanks

 

[Gadorach]

His wiring was bad, as explained. Your wiring is also likely bad. Re-solder your wires using flux and making sure they're connected to the correct points.

- Gadorach

PS. Don't hijack threads. Open a new thread with pictures of your install and an explanation of your problem.

 

[Urban Gamer]

It sounds like a power issue, if your soldering was bad maybe you shorted somthing out and blew a mosfet?? Im sure there are ways to tell which one is blown using a multi meter ect, then just replace it with either one from another board or somewhere in the forums there was a thread where a guy found a replacement on digikey or somthing like that which worked.

Matt