Ok guys i need help my jtag is dead. I lost my nand and cpu key. I found tuts on how to do the donor nand but i dont have my cpu key. I was wondering whati should do first. I know i have to install my LPT cable and then i was wondering should i dump my nand or do the nand recovery. I need tuts on what to do first.
JTAG Dead Jtag Need help
- Thread starter -Alwayzx-
- Start date
Dump current NAND. Flash Xell and get your CPU Key. Follow corresponding tutorials to rebuild NAND. How did your JTAG die though.
My jtag died by a bad flash..... Also lets say the LPT points have been soldered already but the lpt cable isnt there anymore can it still be resoldered?
In my experience I've had horrible luck with LPT even with good solder joints. Others use it all the time so it might be worth investing in a NAND-X but to each his own. If you have the wires still in place but you tore apart your LPT cable just reassemble it and using JTAG Tool dump the NAND and rebuild it with the KV and config using the donor NAND. Is it throwing any codes to signify what may be wrong.
Sent from my DROIDX using Tapatalk
Sent from my DROIDX using Tapatalk
Martin C
VIP Member
Your KV is only in block 1 (block 0 being SMC), so as long as you get a good read of blocks 0-50, you can flash Xellous to your console and using TCP/IP, dump the rest of the NAND contents from there.