Hello,
My drive fried because the input was connected wrongly.
It looks like this one; http://imageshack.us/f/571/dsc0190du.jpg/
http://imageshack.us/photo/my-images/521/dsc0191fx.jpg/
I removed the bad resistors (204/207) and bridged them.
I have continuity between r204 and r66 and I measured the voltage on r66 with ground on the pinout and it gave me 3.3v...So I think I fixed the track...The drive turns (or tries to) on - I can see red laser light, the lens move a little and I think I can hear the dvd motor for breaf moment...But the xbox still blinks green.
I also read I should connect 3.3v input directly on r66, I tried and the results were the same.
I can't test the board on PC today so I'm not sure if it's the board or another drive component...
Thank you for your help.
My drive fried because the input was connected wrongly.
It looks like this one; http://imageshack.us/f/571/dsc0190du.jpg/
http://imageshack.us/photo/my-images/521/dsc0191fx.jpg/
I removed the bad resistors (204/207) and bridged them.
I have continuity between r204 and r66 and I measured the voltage on r66 with ground on the pinout and it gave me 3.3v...So I think I fixed the track...The drive turns (or tries to) on - I can see red laser light, the lens move a little and I think I can hear the dvd motor for breaf moment...But the xbox still blinks green.
I also read I should connect 3.3v input directly on r66, I tried and the results were the same.
I can't test the board on PC today so I'm not sure if it's the board or another drive component...
Thank you for your help.
Last edited: